Ethernet physical layer

Ethernet physical layer

The Ethernet physical layer is the physical layer component of the Ethernet standard.

The Ethernet physical layer evolved over a considerable time span and encompasses quite a few physical media interfaces and several magnitudes of speed. The speed ranges from 3 Mbit/s to 10 Gbit/s in speed while the physical medium can range from bulky coaxial cable to twisted pair to optical fiber.In general, network protocol stack software will work identically on most of the following types.

The following sections provide a brief summary of all the official Ethernet media types (section numbers from the IEEE 802.3-2002 standard are parenthesized). In addition to these official standards, many vendors have implemented proprietary media types for various reasons—often to support longer distances over fiber optic cabling.

Many Ethernet adapters and switch ports support multiple speeds, using autonegotiation to set the speed and duplex for the best values supported by both connected devices. If auto-negotiation fails, a multiple speed device will sense the speed used by its partner, but will assume half-duplex. A 10/100 Ethernet port supports 10BASE-T and 100BASE-TX. A 10/100/1000 Ethernet port supports 10BASE-T, 100BASE-TX, and 1000BASE-T.

Physical layers

Xerox experimental Ethernet

Gigabit Ethernet

All of these use a star topology.

100 Gigabit Ethernet

This is the future version of ethernet and is not expected to be standardized until 2010. This is the proposed nomenclature:

Ethernet over twisted-pair cable

Several varieties of Ethernet were specifically designed to run over 4-pair copper structured cabling already installed in many locations.
ANSI recommends using Category 6 cable for new installations Fact|date=February 2007.

Combining 10Base-T (or 100BASE-TX)with "IEEE 802.3af mode A"allows a hub to transmit both power and data over only two pairs.This was designed to leave the other two pairs free for analog telephone signalsFact|date=February 2007 [http://www.zytrax.com/tech/layer_1/cables/mixed.html] .

The pins used in "IEEE 802.3af Mode B"supplies power over the "spare" pairs not used by 10BASE-T and 100BASE-TX.

In a departure from both 10BASE-T and 100BASE-TX, 1000BASE-T uses all four cable pairs for simultaneous transmission in both directions through the use of echo cancellation.(Dial-up modems also use echo cancellation to simultaneously transmit data in both directions over a single cable pair).

Ethernet Minimum Cable Lengths

All copper Ethernet segments that run the Collision Detect (CD) portion of CSMA/CD have a minimum cable length to function properly because of reflections. This applies only to 10BASE-T and 100BASE-TX standards; The 1000BASE-TX standard is covered at the end of this section.

Fiber connections have minimum cable lengths due to level requirements on received signals [ [http://www.cisco.com/en/US/products/hw/modules/ps5455/products_data_sheet0900aecd801ba88e.html Cisco 100BASE-FX SFP Fast Ethernet Interface Converter on Gigabit SFP Ports] , undated, URL retrieved on 1 June 2007] .

Fiber ports designed for long-haul wavelengths require a signal attenuator if used within a building.

Industrial Ethernet applications use a star topology with no collisions so that no minimum cable length is required.

1000BASE-TX supports half-duplex mode, making collisions possible. Consequently, the 1000BASE-TX standard requires a minimum cable length for collision detection to function properly; to avoid this in Gigabit Ethernet, small frames are padded into the transmission in half-duplex mode [ [http://www.intel.com/network/connectivity/resources/doc_library/white_papers/solutions/copper_guide/gig_over_copper.htm Intel Network Connectivity Solutions Guide] , undated, URL retrieved on 1 June 2007] .

ee also

*Ethernet
*Physical layer
*IEEE 802.3

References

External links

* [http://standards.ieee.org/getieee802/802.3.html Get IEEE 802.3]
* [http://www.ieee802.org/3/ IEEE 802.3]
* [http://www.wikihow.com/Make-a-Network-Cable How to make an Ethernet cable]


Wikimedia Foundation. 2010.

Игры ⚽ Нужна курсовая?

Look at other dictionaries:

  • Physical layer — PHY redirects here. For the drug referred to as Phy, see Methadone. The OSI model 7 Application layer 6 Presentation layer 5 Session layer 4 Transport layer 3 …   Wikipedia

  • Physical Layer — NOTOC The Physical Layer is the first level in the seven layer OSI model of computer networking. It translates communications requests from the Data Link Layer into hardware specific operations to affect transmission or reception of electronic… …   Wikipedia

  • Physical Layer Signaling — ou PLS (signalisation de la couche physique) encore connu sous la dénomination Physical Signaling Sublayer correspond à la partie supérieure de la couche physique dans le modèle OSI de l ISO. PLS assure le couplage fonctionnel et logique entre l… …   Wikipédia en Français

  • Physical Layer — Als OSI Modell (auch ISO OSI Schichtmodell, OSI Referenzmodell; engl. Open Systems Interconnection Reference Model) wird ein Schichtenmodell der Internationalen Standardisierungsorganisation (ISO) bezeichnet. Es wurde als Designgrundlage von… …   Deutsch Wikipedia

  • Ethernet powerlink — является детерминированным в режиме реального времени протоколом для стандартного Ethernet. Это открытый управляемый протокол Ethernet POWERLINK Standardization Group (EPSG). Он был введен австрийской автоматизационной компанией B R в 2001 году.… …   Википедия

  • Ethernet in the First Mile — (EFM), also known as IEEE 802.3ah, is a collection of protocols specified in IEEE 802.3, defining the Ethernet in the access networks, i.e. first or last mile.With Wide, Metro and Local Area Networks already standardized, the EFM allows… …   Wikipedia

  • Ethernet — An 8P8C modular connector (often called RJ45) commonly used on cat 5 cables in Ethernet networks Ethernet   …   Wikipedia

  • Ethernet frame — A data packet on an Ethernet link is called an Ethernet frame. A frame begins with Preamble and Start Frame Delimiter. Following which, each Ethernet frame continues with an Ethernet header featuring destination and source MAC addresses. The… …   Wikipedia

  • Ethernet over twisted pair — cable (upper) and 8P8C plug (lower) Ethernet over twisted pair technologies use twisted pair cables for the physical layer of an Ethernet computer network. Other Ethernet cable standards employ coaxial cable or optical fiber. Early versions… …   Wikipedia

  • Ethernet — Кабель UTP с разъемом 8P8C (ошибочно называемый RJ 45), используемый в Ethernet сетях стандартов 10BASE T, 100BASE T(x) и 1 …   Википедия

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”